The CANopenIA-XA Starter Kit for Direct Digital I/O
| Back to |
| CANopenIA |
The CANopenIA-XA Starter Kit is based on our
COIA-XA Evaboard shown in this picture. The board is equipped with the
COIA-XA module (37 pins, 28.5 by 26 mm) and has DIP switches, LEDs and
sockets for all possible digital I/O lines of ports 0, 1 and 2.
Three special function pins are connected to push buttons to allow for triggering of CANopen events like PDO transmissions or sending emergency messages.
An additional 10-bit DIP switch is provided for the hardware selection of the CANopen node ID and the baud rate.
Contents of the CANopenIA-XA Starter Kit
Hardware:
- COIA-XA Evaboard (evaluation board) with COIA-XA Module (as shown in picture above)
- 9V international power supply
- PEAK PCAN-Dongle
- CAN "Y"-cable
- CAN "1:1"-cable
- CAN termination resistor
- CD with software and manuals
Software:
- PCAN-Dongle driver
- PCAN-View CAN monitor
- CANopenIA-XA Developer's Kit
- PCANopenMagic (CANopen configuration tool)
Training:
A step-by-step training class for the starter kit is available on the "MyAcademy" online training system of ESAcademy.
Pricing and Availability
For pricing and availability of the the starter
kit, contact ESSolutions at
info at essolutions.de.